KROHNE IFC 010 Converter EN - Manual (Page 38)

6/1
Part C Special applications, functional checks,
service, and order numbers
6 Special applications
Please refer to Sect. 3.2 “factory settings”
6.1 HHT 010 hand held terminal and RS 232 adapter incl. CONFIG software (options)
External operator control can be carried out with the following options:
– HHT 010 hand-held terminal only for IFC 010 _ / B signal converter (basic version)
– MS-DOS PC via an RS 232 adapter, incl. CONFIG software for
signal converter IFC 010 _ / B (basic version) and IFC 010 _ / D (display version)
Detailed directions supplied.
Switch off power source before opening the housing !
1) Unscrew the 4 recessed head screws and remove the transparent cover.
2) Plug the HHT connection plug or the RS 232 adapter into the IMoCom Bus socket and
connect to the PC or laptop, see amplifier PCB in Sect. 8.9.
3) Switch on the power.
4) As described in the supplied description, change data, parameters and measured values,
and have them called up for display.
5) Switch off the power.
6) Pull the HHT plug or the RS 232 adapter off the amplifier PCB.
7) Replace transparent cover and tighten down the 4 recessed head screws.