KROHNE H250 M40 EN - Manual (Page 6)

1
SAFETY INSTRUCTIONS
6
H250 M40
www.krohne.com 11/2012 - 4000640702 MA H250 M40 R02 en
1.2 Certifications
The device fulfils all applicable statutory requirements of the following EC directives:
• Pressure equipment directive 97/23/EC
• For devices with electrical installations: EMC Directive 2004/108/EC
• Devices for use in hazardous areas: ATEX Directive 94/9/EC
as well as
• NAMUR recommendations NE 21 and NE 43
The manufacturer certifies successful testing of the product by applying the CE mark.
1.3 Pressure equipment directive
A conformity assessment in accordance with pressure equipment directive 97/23/EC has been
carried out for the devices described. Conformity is certified by applying the CE mark. The
number of the notified body is also stated.
The PED – Key describes rating of devices:
The PED key identification can be found on the nameplate of the device (see section 2.3
Nameplate)
CE marking
PED/G1/III/H
G
Gases and steams
1 Fluid group 1
III Category III
H Conformity assessment method according to Module H
INFORMATION!
The stated pressures (PS) and temperatures (TS) only apply as refers to the pressure resistance
of the sensor body. As regards the functionality of the entire device, further restrictions of the
maximum temperature may need to be observed (e.g. ATEX approval). Devices rated below
Category I (Article 3/3) due to their size, do not receive the CE mark in the scope of the PED.
These devices are subject to applicable Sound Engineering Practice SEP.
MA_H250_M40_R02_en_640702_PRT.book Page 6 Wednesday, November 28, 2012 12:23 PM