Operation – KROHNE OPTISENS MAC 080 EN User Manual

Page 30

OPERATION

OPTISENS MAC 080

www.krohne.com

01/2010 - MA MAC 080 R02 en

6.1.4 Menu topology

There are menus to configure the converter and the sensors. They are divided in two branches,
each having a set of submenus:

• Converter menu, to make changes to the setup of the converter. It is selected by pressing ↑

and ^ simultaneously for five seconds.

• Sensor menus, to make changes to each sensor’s setting, calibration, scale or system

parameters. It is selected by bringing the cursor to the desired sensor, then pressing ^ for
five seconds.

Menu topology

6.1.5 Working in the menus

• A square in front of a line in the menu indicates the top of the menu. If ^ is pressed when this

line is highlighted, the menu is ended.

• An arrow to the right Z indicates that a submenu is displayed if ^ is pressed when this line is

highlighted.

• Pressing ^ on a highlighted line with an arrow to the left Y will take the user back to the

previous menu.

• If there is not enough room on the screen for the menu, an arrow pointing down V is shown

at the end of the screen to indicate that the menu continues. Use the button ↓ to access these
additional lines.

All the menus can be ended anywhere by pressing ↑ + ^ simultaneously to go back to the main
menu or sensor listing screen. It is not necessary to go through the whole screen menu to get
back to the main menu.

Sensor display

Press ^ + ↓ to change between sensor display and main display

Main display

Press ^ for 5 seconds to select sensor menu

Press ^ + ↑ for 5 seconds to select converter menu

Sensor menu

Converter menu

Settings

Calibrate

System

Cleaning

Empty slot

Scale & Alarm

System

.book Page 30 Tuesday, January 19, 2010 1:07 PM