KROHNE IFC 100 Converter FOUNDATION FIELDBUS - Manual (Page 58)

4
OPERATION
58
IFC 100
www.krohne.com 02/2012 - 4001702901 - AD IFC 100 FF R01 en
Value R Value of ROUT_OUT -
SHED_OPT SHED_OPT SHED_OPT SHED_OPT
Shed Options Shed Options Shed Options Shed Options
R/W Defines action to be taken on remote control device timeout. Uninitialized
Setting:
• Uninitialized
• NormalShed_NormalReturn: Actual mode changes to next
lowest priority non-remote mode permitted, but returns to
target remote mode after communications are re-
established
• NormalShed_NoReturn: Target mode changes to next
lowest priority non-remote mode permitted
• ShedToAuto_NormalReturn: Actual mode changes to "Auto",
but returns to target remote mode after communications are
re-established
• ShedToAuto_NoReturn: Target mode changes to "Auto"
• ShedToManual_NormalReturn: Actual mode changes to
"Manual", but returns to target remote mode after
communications are re-established
• NormalShed_NoReturn: Target mode changes to next
lowest priority non-remote mode permitted
• ShedToRetainedTarget_NormalReturn: Shed to previous
target mode and return target remote mode after
communications are re-established
• ShedToRetainedTarget_NoReturn: Target mode changes to
target retained mode
SP SP SP SP
Setpoint Setpoint Setpoint Setpoint
R/W Setpoint 0
Status Status of SP
Value Value of SP
SP_HI_LIM SP_HI_LIM SP_HI_LIM SP_HI_LIM
Setpoint High Limit Setpoint High Limit Setpoint High Limit Setpoint High Limit
R/W The setpoint high limit is the highest setpoint operator entry
that can be used for the block.
100
SP_LO_LIM SP_LO_LIM SP_LO_LIM SP_LO_LIM
Setpoint Low Limit Setpoint Low Limit Setpoint Low Limit Setpoint Low Limit
R/W The setpoint low limit is the highest setpoint operator entry
that can be used for the block.
0
SP_RATE_DN SP_RATE_DN SP_RATE_DN SP_RATE_DN
Setpoint Rate Setpoint Rate Setpoint Rate Setpoint Rate
Down Down Down Down
R/W Ramp rate at which downward setpoint changes are acted on
in "Auto" mode, in PV units per second. If the ramp rate is set
to zero or the block is in a mode other than "Auto", then the
setpoint will be used immediately.
+INF
Setting:
0.0...+INF
SP_RATE_UP SP_RATE_UP SP_RATE_UP SP_RATE_UP
Setpoint Rate Up Setpoint Rate Up Setpoint Rate Up Setpoint Rate Up
R/W Ramp rate at which upward setpoint changes are acted on in
"Auto" mode, in PV units per second. If the ramp rate is set to
zero or the block is in a mode other than "Auto", then the
setpoint will be used immediately.
+INF
Setting:
0.0...+INF
Parameter Parameter Parameter Parameter
Subelement Access Description and settings Initial Value