KROHNE IFC 100 Converter FOUNDATION FIELDBUS - Manual (Page 56)

4
OPERATION
56
IFC 100
www.krohne.com 02/2012 - 4001702901 - AD IFC 100 FF R01 en
Unacknowledged R/W A discrete enumeration which is set to "Unacknowledged"
when an alarm occurs, and set to "Acknowledged" by a write
from a human interface device or other entity which can
acknowledge that the alarm/event has been noticed.
Uninitialized
Setting:
Uninitialized / Acknowledged / Unacknowledged
Alarm State R A discrete enumeration which gives an indication of whether
the alert is active and whether it has been reported.
Uninitialized
Setting:
• Uninitialized
• Clear - reported: Alarm not active and reported
• Clear - not reported: Alarm not active and not reported
• Active - reported: Alarm active and reported
• Active - not reported: Alarm active and not reported
Time Stamp R The time when evaluation of the block was started and a
change in alarm/event state was detected that is unreported.
The time stamp value will be maintained constant until alert
confirmation has been received - even if another change of
state occurs.
Uninitialized
Setting:
MM / DD / YY (Month / Day / Year)
HH:MM:SS (Hour:Minute:Second)
Subcode R An enumeration specifying the cause of the alert to be
reported.
Other
Setting:
Settings see above parameter "BLOCK_ALM", subelement
"Subcode".
Value R The value of the associated parameter at the time the alert
was detected.
0
LO_LO_LIM LO_LO_LIM LO_LO_LIM LO_LO_LIM
Low Low Limit Low Low Limit Low Low Limit Low Low Limit
R/W The setting for Low Low Alarm in engineering units. -INF
LO_LO_PRI LO_LO_PRI LO_LO_PRI LO_LO_PRI
Low Low Priority Low Low Priority Low Low Priority Low Low Priority
R/W Priority of the Low Low Alarm. 0
Setting:
0...15
LO_PRI LO_PRI LO_PRI LO_PRI
Low Priority Low Priority Low Priority Low Priority
R/W Priority of the Low Alarm. 1
Setting:
Max. 15
OUT OUT OUT OUT
Output Output Output Output
Mix The primary analog value calculated as a result of executing
the function block.
-
Status R/W Status of OUT -
Value R/W Value of OUT -
OUT_HI_LIM OUT_HI_LIM OUT_HI_LIM OUT_HI_LIM
Output High Limit Output High Limit Output High Limit Output High Limit
R/W Limits the maximum output value for modes other than
"Manual".
100
OUT_LO_LIM OUT_LO_LIM OUT_LO_LIM OUT_LO_LIM
Output Low Limit Output Low Limit Output Low Limit Output Low Limit
R/W Limits the minimum output value for modes other than
"Manual".
0
OUT_SCALE OUT_SCALE OUT_SCALE OUT_SCALE
Output Scale Output Scale Output Scale Output Scale
R/W The high and low scale values, engineering units code and
number of digits to the right of the decimal point to be used in
displaying the OUT parameter and parameters which have the
same scaling as OUT.
-
EU at 100% R/W The engineering unit value which represents the upper end of
range of the associated block parameter.
100
EU at 0% R/W The engineering unit value which represents the lower end of
range of the associated block parameter.
0
Parameter Parameter Parameter Parameter
Subelement Access Description and settings Initial Value