KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.87 to 3.xx - Manual (Page 80)

B-18
SERIES EL 022013
B.99 SYSTem:FAN? QUERY
SYST:FAN?
Syntax: Short Form: SYST:FAN? Long Form: SYSTem:FAN?
Returns = 0 or 100
Description: Indicates fan status: 0 = off, 100 = on.
B.100 SYSTem:MODE COMMAND
SYST:MODE
Syntax: Short Form: SYST:MODE
Long Form: SYSTem:MODE
Description: Initiates a transient. Sending SYST:MODE TRANS initiates a transient pulse. The operating MODE
(PAR. B.40) determines the type of transient (voltage, current, conductance or resistance) and the
transient parameters are determined by the corresponding transient command: for voltage see
VOLT:TRAN, (PAR. B.62), for current see CURR:TRAN (PAR. B.38), for conductance see
COND:TRAN (PAR. B.30) and for resistance see RES:TRAN (PAR. B.50).
Sending SYST:MODE FIX terminates SYST:MODE TRANS and disables analog programming (sets
SYST:EXT (see PAR. B.96) to OFF.
Sending SYST:MODE EXT terminates SYST:MODE TRANS and enables analog programming (sets
SYST:EXT (see PAR. B.96) to ON.
B.101 SYSTem:MODE? QUERY
SYST:MODE?
Syntax: Short Form: SYST:MODE? Long Form: SYSTem:MODE?
Returns
Description: Indicates SYSTem:MODE status. Returns TRANS if transient is enabled, returns FIX if both transient
and analog programming are disabled, and returns EXT if analog programming is enabled.
B.102 SYSTem:PFModule:DAMPing COMMAND
SYST:PFM:DAMP
Syntax: Short Form: SYST:PFM:DAMP Long Form: SYSTem:PFModule:DAMPing
Where = integer from 0 (minimum damping) to 5 (maximum damping)
Description: Establishes damping settings for Power FET Modules. Increased damping decreases the loop's
response time to transients. Factory default setting is 3.
Damping Settings: 0 - 1nF, 1 - 4.3nF, 2 - 11nF, 3 - 34nF, 4 - 101nF, 5 - 147.3nF. See PAR. 3.14 for
details.
B.103 SYSTem:PFModule:DAMPing? QUERY
SYST:PFM:DAMP?
Syntax: Short Form: SYST:PFM:DAMP? Long Form: SYSTem:PFModule:DAMPing?
Returns = integer from 0 (minimum damping) to 5 (maximum damping)
Description: Indicating damping settings for Power FET Modules. See PAR. 3.14 for details.
B.104 SYSTem:PFModule:LIST? QUERY
SYST:PFM:LIST?
Syntax: Short Form: SYST:PFM:LIST? Long Form: SYSTem:PFModule:LIST?