KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.87 to 3.xx - Manual (Page 79)

SERIES EL 022013
B-17
B.92 SYSTem:COMMunicate:LAN:SUBNetmask? QUERY
SYST:COMM:LAN:SUBN ?
Syntax: Short Form: SYST:COMM:LAN:SUBN?
Long Form: SYSTem:COMMunicate:LAN:SUBNetmask?
Returns: = numbers from 0 to 255 comprising the Subnet Mask
Description: Returns the Subnet Mask used during LAN communication.
B.93 SYSTem:DAMPing COMMAND
SYST:DAMP
Syntax: Short Form: SYST:DAMP x Long Form: SYSTem:DAMPing x
Where x = integer from 0 (minimum damping) to 7 (maximum damping) except units with firmware ver-
sion suffix B2 and lower accept only 0 to 5(maximum)
Description: Inserts capacitance required to damp oscillation. Increased damping reduces the tendency for
oscillation and reduces response time to high speed transients. Units shipped from the factory are
shipped with SYST:DAMP set to 4. See PAR. 3.14 for an explanation of damping as well as a recom-
mended procedure for adjusting damping.
B.94 SYSTem:DAMPing? QUERY
SYST:DAMP?
Syntax: Short Form: SYST:DAMP? Long Form: SYSTem:DAMPing?
Returns x where x = integer from 0 (minimum damping) to 7 (maximum damping) (5 is maximum
damping for units with firmware version suffix B2 or lower)
Description: Inserts capacitance required to damp oscillation. Factory default setting is 7 (default is 5 for units
with firmware version suffix B2 or lower). See PAR. 3.14
B.95 SYSTem:ERRor? QUERY
SYST:ERR?
Syntax: Short Form: SYST:ERR? Long Form: SYSTem:ERRor?
Description: Returns next entry from the error message queue. Responds with the most recent error message
in a queue of up to 10 possible messages and clears each error message as it is sent. Issuing *CLS
clears all error messages in the queue.
Error Message Code
Command Error Generic -100
Invalid Separator
-103
Illegal Parameter Value -224
Invalid Unit Number -241
Queue Overflow -350
No Error -0
B.96 SYSTem:EXTernal COMMAND
SYST:EXT
Syntax: Short Form: SYST:EXT Long Form: SYSTem:EXTernal
where = 0 or OFF for disable, 1 or ON for enable
Description: Enables or disables external analog programming.
B.97 SYSTem:EXTernal? QUERY
SYST:EXT?
Syntax: Short Form: SYST:EXT? Long Form: SYSTem:EXTernal?
Returns: = 0 (disabled) or 1 (enabled)
Description: Indicates whether external analog programming is enabled or disabled.
B.98 SYSTem:FAN COMMAND
SYST:FAN
Syntax: Short Form: SYST:FAN Long Form: SYSTem:FAN
Where = integer, either 0 or 100
Description: SYST:FAN 0 sets fan to off. SYST:FAN 100 sets fan to on.