B.31 [source:]conductance:transient? query, B.34 [source:]current:protection[:level] command, B.35 [source:]current:protection[:level]? query – KEPCO EL Series Electronic Load Operator Manual P/N 243-1295 Firmware Version 3.87 to 3.xx User Manual

Page 70: B.36 [source:]current:protection:state command, B.37 [source:]current:protection:state? query, B.31, Source, B.32, B.33, B.34

B-8

SERIES EL 022013

B.31 [SOURce:]CONDuctance:TRANsient? QUERY

COND:TRAN?

Syntax:

Short Form: [SOUR:]COND:TRAN?
Long Form: [SOURce:]CONDuctance:TRANsient?
Returns: ,,, (see PAR. B.30 for definitions).

Description: Indicates Conductance Transient parameters established by COND:TRAN command (PAR.

B.30.

B.32 [SOURce:]CURRent[:LEVel][:IMMediate][:AMPlitude] COMMAND

CURR

Syntax:

Short Form: [SOUR:]CURR[:LEV][:IMM][:AMP]
Long Form: [SOURce:]CURRent[:LEVel][:IMMediate][:AMPlitude]
Where = current setpoint

Description: Current Setting. The current setpoint affects the load only when the load is in Current mode of opera-

tion. Current setpoint is stored in non-volatile memory; value is restored upon power-up.

B.33 [SOURce:]CURRent[:LEVel][:IMMediate][:AMPlitude]? QUERY

CURR?

Syntax:

Short Form: [SOUR:]CURR[:LEV][:IMM][:AMP]?
Long Form: [SOURce:]CURRent[:LEVel][:IMMediate][:AMPlitude]?
Returns = current setpoint

Description: Indicates Current Setpoint.

B.34 [SOURce:]CURRent:PROTection[:LEVel] COMMAND

CURR:PROT

Syntax:

Short Form: [SOUR:]CURR:PROT[:LEV]
Long Form: [SOURce:]CURRent:PROTection[:LEVel]
where: = current protection setpoint

Description: Establishes current protection setpoint. Current protection setpoint is stored in non-volatile mem-

ory; value is restored upon power-up. This is a user-defined value which, if exceeded during opera-
tion, causes a FAULT condition, forcing the load to disengage.

B.35 [SOURce:]CURRent:PROTection[:LEVel]? QUERY

CURR:PROT?

Syntax:

Short Form: [SOUR:]CURR:PROT[:LEV]?
Long Form: [SOURce:]CURRent:PROTection[:LEVel]?
Returns: = current protection setpoint

Description: Indicates current protection setpoint.

B.36 [SOURce:]CURRent:PROTection:STATe COMMAND

CURR:PROT:STAT 0

Syntax:

Short Form: [SOUR:]CURR:PROT:STAT 0
Long Form: [SOURce:]CURRent:PROTection:STATe 0

Description: Clears current protection level error.

B.37 [SOURce:]CURRent:PROTection:STATe? QUERY

CURR:PROT:STAT?

Syntax:

Short Form: [SOUR:]CURR:PROT:STAT?
Long Form: [SOURce:]CURRent:PROTection:STATe?
Returns: = 1 (current protection error occurred)

0 (current protection error has not occurred)

Description: Indicates whether a current protection error has occurred (1) or not (0).