B.139 system:password:new command, B.140 system:password:state? query, B.141 system:remote command – KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.3.05 to 4.07 User Manual
Page 188: B.142 system:remote? query, B.143 system:security:immediate command, B.139, Syst, B.140, B.141, B.142
B-34
BOP-1K 031912
B.139 SYSTem:PASSword:NEW COMMAND
SYST:PASS:NEW
Syntax:
Short Form: SYST:PASS:NEW
Long Form: SYSTem:PASSword:NEW
Description: Establishes new password. The old (current) Main password is checked, then replaced by the new
password. Admin 1 and 2 passwords (PAR. 3.2.4.3) are not available. (See example, Figure B-12.)
See PAR. 3.5.2.2 and Figure 3-16 for special programming considerations.
B.140 SYSTem:PASSword:STATe? QUERY
SYST:PASS:STAT?
Syntax:
Short Form: SYST:PASS:STAT?
Long Form: SYSTem:PASSword:STATe?
Return Value:
Description: Returns a 1 if the password state is enabled or a 0 if it is disabled.
B.141 SYSTem:REMote COMMAND
SYST:REM
Syntax:
Short Form: SYST:REM {ON | OFF} or {1 | 0}
Long Form: SYSTem:REMote {ON | OFF} or {1 | 0}
Description: Used during serial (RS 232) communication to set the unit to remote (1 or ON) or local (0 or
OFF) mode. This command must be issued prior to commands that affect the power supply output
(e.g., VOLT 10;:OUTP ON) to ensure the unit is in remote mode. See PAR. 3.5.6.3 and Figure B-11.
B.142 SYSTem:REMote? QUERY
SYST:REM?
Syntax:
Short Form: SYST:REM?
Long Form: SYSTem:REMote?
Return Value: {1 | 0}
Description: Identifies whether unit it in remote mode (1) or local mode (0) during serial (RS 232) communi-
cation. See PAR. 3.5.6.3 and Figure B-11.
FIGURE B-11. SETTING THE UNIT TO REMOTE MODE VIA SERIAL (RS 232) PORT
B.143 SYSTem:SECurity:IMMediate COMMAND
SYST:SEC:IMM
Syntax:
Short Form: SYST:SEC:IMM
Long Form: SYSTem:SECurity:IMMediate
Description: Initializes all NVRAM variable to factory defaults. Empties all memory locations. See PAR. 3.5.2.2
and Figure 3-16 for special programming considerations. This command is password protected (must
be preceded by SYST:PASS:CEN (see PAR B.137).
*IDN?
Unit responds with KEPCO,BOP 50-20,E1234,1.66 (typical).
OUTP?
Unit responds with 0 indicating output is off
SYST:REM?
Unit responds with 0 indicating unit is in local mode.
SYST:REM 1
Puts unit in remote mode.
OUTP ON
Enables output
OUTP?
Unit responds with 1 (output on).
SYST:REM 0
Unit set to local mode.