KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.3.05 to 4.07 - Manual (Page 114)

3-50
BOP HIPWR 031912
3.5.5 BOP VISA INSTRUMENT DRIVER
The VISA instrument driver for the BOP power supply, available for download at www.kepco-
power.com/drivers.htm, simplifies programming with a VISA compatible GPIB controller.
Included are:
• source code (C) for all VISA functions (kp_bophi.c)
• a complete programming reference manual (kp_bophi.doc)
• a sample application of the VISA functions (written in C) which can be used to program
one or more BOP power supplies using a virtual front panel observed on a com-
puter monitor (kp_appl.c)
TABLE 3-19. IEEE 488 (GPIB) BUS COMMAND MODE MESSAGES
MNEMONIC
MESSAGE
DESCRIPTION
COMMENTS
ATN Attention Received
DAC Data accepted Received or Sent
DAV Data Valid Received or Sent
DCL Device Clear Received (see PAR. 3.5.3.1.2)
IFC Interface Clear Received
MLA My Listen Address Received
MTA My Talk Address Received
OTA Other Talk Address Received
RFD Ready for Data Received or Sent
SDC Selected Device Clear Received
SPD Serial Poll Disable Received
SPE Serial Poll Enable Received
SRQ Service Request Sent
UNL Unlisten Received
UNT Untalk Received
TABLE 3-20. IEEE 488 (GPIB) BUS DATA MODE MESSAGES
MNEMONIC MESSAGE DESCRIPTION COMMENTS
DAB Data Byte Received or Sent
END End Received or Sent
EOS End of String Received or Sent
RQS Request Service Sent
STB Status Byte Sent