KEPCO BOP 1KW-MG Operator Manual, Firmware Ver.3.05 to 4.07 - Manual (Page 157)

BOP-1K 031912
B-3
B.5 INITiate[:IMMediate] COMMAND
INIT[:IMM]
Syntax: Short Form: INIT:[IMM] Long Form: INITiate[:IMMediate]
Description: Enables a single trigger. This command enables a single trigger. A *TRG command completes the
sequence, however TRIG:SOUR (see PAR. B.147) must be set to BUS. Upon receipt of the *TRG
command, the power supply will return to the commanded values of voltage and current established
by the VOLT:TRIG and CURR:TRIG commands. After a *TRG command has been received, subse-
quent *TRG commands have no effect unless preceded by INIT or INIT:CONT ON. Related Com-
mands: *TRG, TRIG, TRIG:SOUR. (See example, Figure B-1.)
FIGURE B-1. PROGRAMMING THE OUTPUT
CAL:CEXT command
CAL:CGA command
CAL:CLIM command
CAL:CPR command
CAL:CURR[:DATA] command
CAL:DATA value command
CAL:DPOT command
CAL:SAVE command CAL:STAT command and query
CAL:VEXT command
CAL:VGA command
CAL:VLIM command
CAL:VOLT[:DATA] command
CAL:VPR command
CAL:ZERO command
NOTES: 1. The power supply is assumed to be operating in constant voltage mode.
2 Examples below are intended only to illustrate command functions. Refer to PAR. 3.5.2 for pro-
gramming techniques to optimize performance.
OUTP ON Turns the output on.
VOLT 21; CURR 1.5 Power supply output programmed to go to 21V, current limit 1.5A
INIT:CONT ON Continuous triggers enabled.
INIT:CONT? Power supply returns “1.”
TRIG:SOUR BUS Prepare unit to wait for *TRG.
VOLT:TRIG 15;CURR:TRIG 3 Power supply output programmed to return to 15V, current limit
3A upon receipt of trigger.
*TRG Power supply output returns to 15V,current limit 3A.
VOLT 21; CURR 5E-2 Power supply output programmed to go to 21V, current limit 0.05A
MEAS:VOLT? If actual value of output voltage is 20.99V, power supply
returns 2.099E1 within the limits of readback accuracy.
MEAS:CURR? If actual value of output current is 0.0499A, power supply
returns 4.99E-2 within the limits of readback accuracy.
FUNC:MODE CURR Establishes constant current mode as power supply operating mode.
VOLT 21; CURR 1.1 Power supply programmed to voltage limit 21V, 1.1A.
CURR? Returns 1.1.
FUNC:MODE VOLT Establishes constant voltage mode as power supply operating mode.
CURR:TRIG? Returns 3 (current value established by CURR:TRIG).
VOLT:TRIG? Returns 15 (voltage value established by VOLT:TRIG).
*TRG Power supply output returns to 15V, current limit 3A.
INIT:CONT 0 Triggers disabled.
INIT:CONT? Power supply returns “0.”
VOLT 0 Power supply output programmed to go to 0V.
MEAS:VOLT? Returns 0 within the limits of readback accuracy (measured output
voltage).
VOLT? Returns 0 within the limits of readback accuracy (programmed output
voltage).
CURR? Returns 3 (programmed current).
MEAS:CURR? Returns 0 within the limits of readback accuracy (measured output
current).