KEPCO BIT 4886 Operator Manual - Manual (Page 8)

vi
BIT 488612413
LIST OF TABLES
TABLE TITLE PAGE
1-1 Applicability of BIT 4886 Cards to Specific BOP Models ........................................................................... 1-1
1-2 BOP Voltage Specifications with BIT 4886 Installed .................................................................................. 1-2
1-3 BOP Current Specifications with BIT 4886 Installed .................................................................................. 1-2
1-4 Specifications, BIT 4886 ............................................................................................................................. 1-3
1-5 Command Differences for BIT 4886 card Configured as BIT 4882 ............................................................ 1-4
2-1 Items Supplied ............................................................................................................................................ 2-1
2-2 Device Address Selection .......................................................................................................................... 2-3
2-3 Input/Output Pin Assignments .................................................................................................................... 2-6
2-4 RS232C PORT Input/Output Pin Assignments .......................................................................................... 2-7
2-5 RJ45 to DB9 Adapter Wire Functions ........................................................................................................ 2-7
3-1 Calibration Measurements and Tolerances - Voltage ................................................................................ 3-3
3-2 Calibration Measurements and Tolerances - Current ................................................................................ 3-4
3-3 Suggested Sense Resistors ....................................................................................................................... 3-5
3-4 Calibration Panel Functions ....................................................................................................................... 3-10
4-1 Built-in test Error Codes ............................................................................................................................. 4-8
4-2 IEEE 488 (GPIB) Bus Interface Functions ................................................................................................. 4-9
4-3 IEEE 488 (GPIB) Bus Command Mode Messages .................................................................................... 4-10
4-4 IEEE 488 (GPIB) Bus Data Mode Messages ............................................................................................. 4-11
4-5 Enhanced Operation - Error Response ...................................................................................................... 4-24
4-6 Calibration Storage ..................................................................................................................................... 4-27
A-1 IEEE 488.2 Command/query Index ............................................................................................................A-1
A-2 Standard Event Status Enable Register and Standard Event Status Register Bits ...................................A-1
A-3 Service Request Enable and Status Byte Register Bits .............................................................................A-5
B-1 SCPI Subsystem Command/query Index ...................................................................................................B-1
B-2 List Data Table ...........................................................................................................................................B-7
B-3 List Sequence Table ...................................................................................................................................B-12
B-4 Operation Condition Register, Operation Enable Register,
and Operation Event Register Bits ..........................................................................................................B-18
B-5 Questionable Event Register, Questionable Condition Register
and Questionable Condition Enable Register Bits ...................................................................................B-19
B-6 Error Messages ..........................................................................................................................................B-22