KEPCO BIT 4886 Operator Manual - Manual (Page 49)

BIT 4886 120413
4-15
FIGURE 4-5. TREE DIAGRAM OF SCPI COMMANDS USED WITH BIT 4886 INTERFACE CARD
4.6.3.1 INITIATE SUBSYSTEM
This subsystem enables the trigger system. When a trigger is enabled, the triggering action will
occur upon receipt of a GPIB , *TRG or TRIGger command. If a trigger circuit is not
enabled, all trigger commands are ignored.
4.6.3.2 MEASURE SUBSYSTEM
This query subsystem returns the voltage and current measured at the power supply's output
terminals.
ROOT : (colon)
CALibrate subsystem
CALibrate
:STATus
:STATus?
:VOLT
:LEVel (MIN | MAX, ZERO)
[:DATA] val
GAIN (UP | DOWN)
:VPR (MIN | MAX)
:CPR (MIN | MAX)
:CURR
:LEVel (MIN | MAX, ZERO)
[:DATA] val
:GAIN (UP | DOWN)
:DPOT val
:LCURR (MIN | MAX, ZERO)
:LVOLT (MIN | MAX, ZERO)
:ZERO
:SAVE
LIST subsystem
LIST
:CLEar
:COUNt val
:COUNt:SKIP val
:CURRent val,val
:POINts?
:DIRection (UP|DOWN)
:DWELl val,val
:POINts?
:GENeration (SEQ|DSEQ)
:QUERy val
:VOLTage val,val
:POINts?
:SEQuence val,val
INITiate subsystem
INITiate
[:IMMediate]
:CONTinuous
MEASure subsystem
MEASure
:CURRent?
:VOLTage?
[ SOURce:] subsystem
[SOURce:]
VOLTage
[:LEVel]
[:IMMediate]
:TRIGgered
:MODE (LIST|FIX|TRANS val)
:RANGe
:RANGe:AUTO
CURRent
[:LEVel]
[:IMMediate]
:TRIGgered
:MODE (LIST|FIX|TRANS val)
:RANGe
:RANGe:AUTO
FUNCtion
:MODE (VOLT|CURR)
:TRIGgered
OUTPut subsystem
OUTPut
[:STATe] ON or OFF
STATus subsystem
STATus
:OPERation
:CONDition?
:ENABle
[:EVENt]?
:PRESet
:QUEStionable
:CONDition?
:ENABle
[:EVENt]?
SYSTem subsystem
SYSTem
:BEEP
:COM
:SER
:ECHO, ?
:PACE, ?
:ERRor
[:NEXT]?
:CODE?
[:NEXT]?
:ALL?
:PASSword
[:CENAble] (code)
:STATe?
:CDISable (code)
:NEW (OLD | NEW)
:SECUrity
:IMMediate
:REM, ?
:SET
:VERSion?