GW Instek SFG-1000 Series - Manual (Page 17)

Getting Started
17
Power up
1. Check the voltage
level displayed on the
label(1) and make
sure it is identical to
the AC line. Then
connect the power
cord(2).
2. Push and turn On the
main power switch
on the front panel.
3. The display shows the default setup:
Sine wave, 1kHz
Functionality
check
1. Connect SFG main output to measurement device
such as oscilloscope.
2. Press the output key. The
output is activated and the
LED turns On.
3. Observe the output waveform: 1kHz, sine wave.