Menu mode, 4 menu mode – Detcon SmartWireless CXT User Manual
Page 26

Sentinel CXT
Sentinel CXT Instruction Manual
Rev. 1.5
Page 22 of 42
DC POWER = Communicating; line powered.
BATT ERR = Communicating; cannot read smart battery pack.
LOW BATT = Communicating; smart battery time to empty below the set threshold.
45+ DAYS = Communicating; smart battery pack has more than 45 days before empty.
0-45 DAYS = Communicating; the number of days until smart battery pack is empty.
YYY% - represents the link quality of the transceiver.
5.4 Menu Mode
1. The PROG switch is used to enter the menu mode of the unit by swiping a programming magnet
over the corresponding marker (
). Once in the menus, all Modbus™ polling stops, sensor values
are not read and alarm outputs are not updated.
NOTE
If the CXT is in alarm when the user enters the menu, it will stay in alarm until they exit the
menu.
2. Upon entering the MAIN MENU, the LCD will display the following:
MAIN MENU
AUTO CONFIGURE SYSTEM
3. Use the down arrow "" switch to move to the next menu item or use the up arrow "" switch to
move to the previous menu item by swiping the programming magnet over the corresponding
markers. Swiping the PROG switch again will return the unit to normal operation.
4. Swipe the ENTER marker when the appropriate menu item is located to enter the menu.
The Main Menu and consists of seven menu items:
1. Auto Configure System
2. Set Channel Alarms
3. Set Relay Function
4. Inhibit & Alarm Test Mode
5. System Diagnostics
6. Time and Date
7. View TWA & Peak
Reference the Menu Flow Chart (Figure 20) to learn how to easily navigate the menus and make changes.