Detcon SmartWireless CXT - Manual (Page 16)

Sentinel CXT
Sentinel CXT Instruction Manual Rev. 1.5 Page 12 of 42
Warning
All Turck cable connectors have dust/water sealing caps that are mandatory to be
installed on any connector that is not actively connected to a cable.
This is
required to maintain the safety rating of this device. These caps are tethered
adjacent to each of the connector fittings for convenient connection.
CAUTION
The user must consult this manual for more information about any location marked
with this symbol.
DANGER
Danger of electrical shock. User must ensure that power has been disconnected
prior to installation or servicing of the equipment.
Warning
When moving the base CXT controller unit, handle it with 2 hands securely
around the body of the unit so as to prevent a possible dropping or lifting hazard.
Warning
When wall mounting the CXT Controller unit, make sure to have 2 people
working together and follow the recommended wall mounting instruction in
Section 3.1.9, which requires suitable securement that holds four times the weight
of the unit. This will prevent chances of a dropping hazard during the installation
or prevent the risk of the unit falling off from the wall mount.
Warning
When moving or manipulating the CXT Controller unit mounted to the Tripod
Assembly, 2 people are required to work together to avoid possible lifting risk.
Do not place your fingers in the areas of the sliding tripod legs as there is risk of
hand injury. Personnel should wear safety gloves while moving and setting up the
tripod assembly.
Warning
To avoid accidental tip-over risk of injury, press and anchor the 3 pointed legs of
the tripod deep and firmly into the soft ground. If the ground is too hard for use
of the point, use an independent anchored pin and a short chain connecting to each
leg to secure the unit.
Warning
To avoid a tripping hazard, hang a brightly colored flag type marker half down
each tripod leg to provide visual warning of the location of the tripod legs.
Warning
To avoid any possible ergonomic risk in interfacing with the CXT unit, make sure
it is installed at a height of 4-5 feet. Place the unit in place where it is easy to
access the front of the unit and as possible avoid placing it where there is constant
direct sunlight.