AW Gear Meters EMO-1005 - Manual (Page 8)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.awgearmeters.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1a 05/98 EMO-1005 Manual.DOC
7
RATE
FLO
To display the rate press the FLO key. The Rate Mode displays the current
incoming frequency for the channel selected on line 1. The displayed frequency
is initially displayed in Hz. But the display can be programmed to any of the 28
familiar engineering units. For further information see the Programming section,
page 11.
The rate will be displayed in the following form:
LINE 1 01:XXXXX.XXXzzzz
LINE 2
where,
01: is the channel number
XXXXX.XXX is the derived rate
zzzz is the selected engineering units
Sample engineering units: Hz, GPM, cc/m, li/m, etc.
The default unit is Hz.
TOTAL
TOT
To display the totalized amount press the TOT key. The Total Mode displays
the current totalized incoming frequency on the channel selected in line 1. The
totalized amount is initially displayed in impulses but the display can be
programmed to any of 14 engineering units. For further information see the
Programming section, page 12 .
The totalized amount will be displayed in the following form:
LINE 1 01:XXXXX.XXXzzzz
LINE 2
where,
01: is the channel number
XXXXX.XXX is the derived totalized amount
zzzz is the selected engineering units
Sample engineering units: Imp, Gal, cc, REV, etc.
The default unit is Imp.
The Totalizer displayed on line one can be reset tozero by pressing the 0 (Zero) key on the
keyboard
.