AW Gear Meters EMO-1005 - Manual (Page 38)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.awgearmeters.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1a 05/98 EMO-1005 Manual.DOC
37
BACK PANEL DETAILS
Before hooking up the EMO-1005 it would be advisable to read this complete section.
The EMO-1005 consists of a POWER SUPPLY CARD and at least one CHANNEL CARD. The
regular EMO-1005 could be equipped to hold 4 CHANNEL CARDS. In the expanded chassis model
the case can hold as many as 14 Channel cards. The 5" units holds up to 4 channels, the 10" unit up to
12 channels, and the 15" unit up to 14 (15) channels. Looking from the rear into the unit the cards are
arranged as on drawing EMO10903, Appendix E. The EMO-1005 is a CMOS based computer. This
means the unit will draw very little power from the 110VAC line. A separate 20 Amp. line is
recommended for the unit although the power consumption will be less than 2 Amps.
The location next to the power supply card can only have the Channel 1 card installed.
The other locations are for channel 2 and up. Any of these channel card can be in any of these locations
and still work properly. But, it is advisable that channel 2 is next to channel 1 and so on. Doing this
will keep the channel numbers in order. If there is a question about the channel number designation of a
card, pull the card out of the chassis and read the label on top of the EPROM IC chip located on the
card (see drawing EMO10904, Appendix F, for location)