AW Gear Meters EMO-1005 - Manual (Page 3)

AW-Lake Company 8809 Industrial Drive, Franksville, WI 53126  web: www.awgearmeters.com
 Tel: 262-884-9800  Fax: 262-884-9810  Email: [email protected]
REV. 1a 05/98 EMO-1005 Manual.DOC
2
INTRODUCTION
The EMO-1005 is a multi channel indicating, computing and signal processing system, applicable in
single channel use and expandable to systems with as many as 250 independently operating channels.
All its functions can be programmed through the programming keyboard in the front panel or
optionally, by a host computer through a RS 422 (RS 232 option) serial port.
There are 5 selectable modes of operation (see page 19); the most popular are either MONITOR or
PID (closed loop). In any mode both instantaneous flow rate and batch totalizing can be displayed
simultaneously.
The main housing is equipped to hold four channel cards, the display board, the programming
keyboard, the communication port and the power supply.
The display is a 16 character, two line alphanumeric Super-Twist LCD with back-lighting for improved
readability in non-daylight situations.
Before installation read HARDWARE HINTS (page 38)
Each channel can be programmed with the following information:
- Rate scale and engineering units
- Totalizer scaling and engineering units
- Rate limit settings (four)
- Totalizer limit settings (four)
- Analog Output Gain
- Analog Output Offset
- Sample amount
- Cut-off frequency
- Analog Input Gain
- Monitor or PI mode
- Linearizer setting (10 points with linear interpolation between points)
Display of rate ratio between any two of the channels can also be programmed.