Seed Hawk AIRCART 2015 - Manual (Page 77)

SEED HAWK ® 2015 AIRCART OPERATOR’S MANUAL 72
8.3.2 Viper Pro™ Calibration
ATTENTION! Before a meter calibration can be done, the implement width
must be entered and the speed calibration must be completed (refer to the Sec-
tion Setup Wizard and Calculating the speed Calibration sections of your Seed
Hawk Viper Pro™ Manual). Exit to the Seed Hawk Viper Pro
™ Main Menu on
the Viper monitor before powering up the Remote Calibration Console.
NOTE: For convenient cali-
bration, use the remote cali-
bration console that attaches
to the tank harness.
To begin the remote calibration of
the meters mount the remote cali-
bration console on the ram-ball and
attach the electrical connector. Turn
the console on using the blue
Power
Key.
1. Remove the plate on the bottom
of the meter and place the calibration
under the meter as shown. 2. Turn the diverter valve to the
lower air stream position for calibra-
tion (return to proper position after
calibration is complete).
If operating an SCT ® equipped machine, ensure meter gates are fully open for
proper product flow.
8.3.1.1 Pre-Calibration Setup
Measure and record the weight of the empty calibration bucket.
Calibration Bucket Weight: _________________