Seed Hawk AIRCART 2015 - Manual (Page 4)

SEED HAWK ® 2015 AIRCART OPERATOR’S MANUAL iii
8.0 HYDRAULIC DRIVE
8.1 Roller Changing Procedure ...........................................................................
8.2 Filter & Pressure Reducing Valve ...............................................................
8.2.1 Hydraulic Oil Filter ..........................................................................................
8.2.2 Pressure Reducing Valve (PRV) .......................................................................
8.3 Remote Calibration ..........................................................................................
8.3.1 Viper Pro
™ Hydraulic Drive Calibration ....................................................
8.3.1.1 Pre-Calibration Setup ...............................................................................
8.3.2 Viper Pro
™ Calibration ..................................................................................
8.4 Meter RPM Chart ..............................................................................................
69
69
70
70
70
71
71
72
72
76
9.0 TROUBLESHOOTING SCT ®
EQUIPPED MACHINES
9.1 Nodes on SCT ® Implements ........................................................................
9.1.1 Node Light Definitions ...................................................................................
9.1.1.1 Diagnosing Node Lights ..........................................................................
9.1.2 Node Diagram ..................................................................................................
9.1.3 Node Locations ................................................................................................
77
79
80
80
80
81
7.5.1 Pre-Calibration Setup ......................................................................................
7.5.2 Loup III Calibration Procedure .....................................................................
7.5.3 Clear Field Acres ..............................................................................................
7.5.4 Rate Controller Meter Setup ........................................................................
7.5.5 Seeder Stationary Mode .................................................................................
7.5.6 Remove All Sensors ........................................................................................
7.6 Alarms .....................................................................................................................
7.7 Normal Operation ............................................................................................
7.7.1 Engage Drive .....................................................................................................
7.7.2 Disengage Drive ...............................................................................................
7.7.3 Adjust Application Rate ...................................................................................
7.7.4 Shank Pressure ..................................................................................................
7.8 Troubleshooting Loup III System ...............................................................
7.8.1 Error Messages ................................................................................................. 56
56
58
58
59
60
60
61
62
62
63
63
65
66
10.1 Wiring Harness - TBH Aircart ...................................................................
10.2 Wiring Harness - TBT Aircart ...................................................................
83
83
85
10.0 Wiring Harness
89 11.0 INDEX