Seed Hawk AIRCART 2015 - Manual (Page 28)

SEED HAWK ® 2015 AIRCART OPERATOR’S MANUAL 23
4.2.3 Pairing the Remote
The remote should arrive ready for the customer to use, but if it becomes un-
paired from the receiver or a replacement remote is purchased, it is necessary
to register the remote with the receiver.
1. Switch off or disconnect the power to the receiver by following the wires
from the receiver, back to the harness and disconnecting, OR disconnecting and
reconnecting harness at tractor.
2. Switch on or reconnect the power to the receiver. This opens a 20 second
registration window in the receiver. If you are looking at the receiver circuit
board, the fault LED flashes.
3. Immediately press and hold the Reset Button (green button) for a min-
imum of 10 seconds during this 20 second window. When the Transmitter is
registered the fault LED goes out, and the set LED comes on.
4.The transmitter can now communicate with the receiver, and a light on the
receiver flashes with each button press on the transmitter
CAUTION! Be sure to stand clear of the fill auger or
conveyor when using the remote. An unexpected button
press could swing the implement into the operator or a
bystander causing bodily harm.
NOTE: A second person may
be required to disconnect
and reconnect power at
tractor to ensure 20 second
window does not time out.