Seed Hawk AIRCART 2015 - Manual (Page 67)

SEED HAWK ® 2015 AIRCART OPERATOR’S MANUAL 62
7.7.1 Engage Drive
• There must be an implement width entered.
• There must be a meter application rate entered.
• There must be a meter calibration rate entered.
• Forward travel speed must be present.
• The drive must be engaged.
The monitor requires several pieces of information for field operation.
To engage the drive press the ACK
(Activate Clutch Key). The drive
icon in the upper center portion of
the screen will turn solid. Engaging the
drive will cause the furrow openers
to lower to seeding position and with
travel speed present the rate meters
will begin to turn.
At the end of a seeding pass, press the
ACK (Activate Clutch Key) again
to disengage the meter drive. This will
stop the application rate meters and
raise the furrow openers. This will
also stop the field area accumulation
register. NOTE: The fans must be
running before engaging the
drive. If the fans are not
operating normally, an alarm
screen will display, alerting
the operator to the problem.
7.7.2 Disengage Drive