Seed Hawk AIRCART 2015 - Manual (Page 27)

SEED HAWK ® 2015 AIRCART OPERATOR’S MANUAL 22
4.2.2 Labeled Lodar Receiver Diagram
LED marked “SET”
indicates system is active.
LED marked “5V” Indicates power
supply for control circuits is
OK.
LED’s marked “F1-F2-F3-F4-F5-F6 and M” When ON
indicate an output to that function.
LED marked “FAULT” Indicates an overload is
present; the System cannot be
RESET until overload
is removed. This LED blinks for 20 seconds when the
Receiver is initially powered. A replacement Transmitter
has to be registered during this 20 second period.
F1
F2
F3
F5
F4
M
F6
Voltage
Working Range: 12 Volts to 36 Volts DC.
Limits: 8 Volts minimum to 40 Volts absolute max.
NOTE: 42 Volt System (48 Volt Max is currently Special Order.)