beautypg.com

Controller basics – Hired-Hand System 1000 Power Vent User Manual

Page 5

background image

System 1000 Power Vent

System 1000 Power Vent

Controller Basics

Controller Basics

••

2

2

Controller Basics

Controller Basics

The front of the controller is known as the facepad. This is where all

operational commands are given, and current condition information is
received. There are ten pressure sensitive "buttons" on the facepad.
These "buttons" are the red colored arrows and rounded squares. To
operate the controller, press the square, or arrow desired. The functions
of the ten buttons are as follows:

Auto On -- Shifts the controller into automatic mode. Either ramped or
constant pressure mode are available with this option. Note: Automatic
Mode refers only to the action of the vent machine(s). The stages will
continuously try to maintain temperature even while the controller is in
manual mode.

Target Temperature Up or Down Arrows -- Used to raise or lower
target temperature, or target pressure while in automatic mode.

Close -- Used to close the vents when in manual mode.

Off -- Used to stop vent motion in manual mode, or to switch from
automatic to manual.

Open -- Used to open the vents in manual mode.

Select Feature Up or Down Arrows -- Used to view selected features
while programming, also used to select features for alteration while
operating.

Change Setting Up or Down Arrows -- Used to adjust setpoints, turn
selected features on, or off, also to answer yes (up), or no (down) to
questions presented by the Controller during programming.