Programming stages, Example – Hired-Hand System 1000 Power Vent User Manual

Page 18

System 1000 Power Vent

Programming Stages

••

Programming Stages

Use the Select Feature up arrow key to select "Program Stages".

When the menu is displayed, use the Change Setting up arrow key to
select yes, you want to program Stage 1. Your first task will be selecting
the mode (heating or cooling) for the stage. Below is a list of several
different modes. Your choice will depend on how you desire to
program your building.

Example

First: Select desired mode by pressing the Change Setting up or down

arrow keys. Below are several modes to choose from. (Heat Mode is
typically programmed here.)

Heat Mode: The stage may only operate when the curtains are
in the closed position.

Cool Negative: This stage will only operate when the curtains
are in the closed position.

Cool Tunnel: The stage will only operate when The System has
switched to Tunnel Mode via the Outside Sensor Control
mechanism and when the curtains are correctly positioned.

Cool Negative Tunnel: This mode will operate a combination of
the Cool Negative and the Cool Tunnel Mode.

Cool Stir: This mode is allowed to operate anytime the
controller is not in tunnel mode.

Second: Select the sensor or sensors you desire to use in Stage 1. Use the

Change Setting up and down arrow keys to choose your Stage 1
sensors.