Brocade Virtual ADX Installation and Deployment Guide (Supporting ADX v03.1.00) - Manual (Page 72)

FIGURE 24 Deploying SLB in One-arm topology without VLAN tagging
Configuring SLB in One-arm topology without VLAN tagging
Virtual ADX#config term
Virtual ADX(config)#vlan 100
Virtual ADX(config-vlan-100)#untag eth 1
added untagged port ethe 1 to port-vlan 100.
Virtual ADX(config-vlan-100)#router-interface ve 1
Virtual ADX(config-vlan-100)#int ve 1
Virtual ADX(config-vif-1)#ip address 192.168.1.9 255.255.255.0
Virtual ADX(config-vif-1)#exit
Virtual ADX(config)#vlan 200
Virtual ADX(config-vlan-200)#untag eth 2
added untagged port ethe 2 to port-vlan 200.
Virtual ADX(config-vlan-200)#router-interface ve 2
Virtual ADX(config-vlan-200)#int ve 2
Virtual ADX(config-vif-2)#ip address 192.167.1.9 255.255.255.0
Virtual ADX(config-vif-2)#exit
Virtual ADX(config)#server real rs1 192.168.1.10
Virtual ADX(config-rs-rs1)#port http
Virtual ADX(config-rs-rs1)#exit
Virtual ADX(config)#server real rs2 192.167.1.10
Virtual ADX(config-rs-rs2)#port http
Virtual ADX(config-rs-rs2)#server virtual v1 192.166.1.10
Virtual ADX(config-vs-v1)#port http
Virtual ADX(config-vs-v1)#bind http rs1 http rs2 http
Virtual ADX(config-vs-v1)#wr mem
Write /opt/ADX/conf/startup-config in progress.
Write /opt/ADX/conf/startup-config done.
Virtual ADX(config-vs-v1)#
Configuring SLB in One-arm topology without VLAN tagging
72 Brocade Virtual ADX Installation and Deployment Guide
53-1003241-01