Brocade Virtual ADX Installation and Deployment Guide (Supporting ADX v03.1.00) - Manual (Page 38)

a) in Linux, open the Virtual Machine Manager application from Application > System
Tools.
b) Right click on Brocade Virtual ADX in the guest VM list and select Open to access to the
console.
c) Select Virtual Machine > Shutdown > Shutdown, to shut down the VM.
NOTE
Failure to perform a shutdown prior to adding or removing interfaces, will cause unexpected
behavior on Brocade Virtual ADX.
2. Select Show Virtual Hardware Details > Add Hardware to add or remove an interface as shown
in the figure below.
FIGURE 11 KVM: Add or remove an interface
NOTE
Interfaces must be added in interface number order i.e. 4, 5, 6, 7, 8 and removed in reverse order
i.e. 8, 7, 6, 5, 4. Adding or removing interfaces in any other order will generate a random order of
interfaces on the VM. To ensure proper functioning on the Brocade Virtual ADX, disable (rather than
remove) an interface from the middle of the configured range of interfaces.
3. If you want to add or remove another interface, return to Step 2.
Brocade Virtual ADX Installation on KVM Host
38 Brocade Virtual ADX Installation and Deployment Guide
53-1003241-01