Brocade Fabric OS Troubleshooting and Diagnostics Guide (Supporting Fabric OS v7.3.0) - Manual (Page 23)

Fabric OS Troubleshooting and Diagnostics Guide 7
53-1003141-01
Building a case for your switch support provider
1
Capturing output from a console
Some information, such as boot information is only outputted directly to the console. To capture
this information, you must connect directly to the switch through its management interface, either
a serial cable or an RJ-45 connector that is specifically used for Ethernet connection to the
management network.
1. Connect directly to the switch using hyperterminal.
2. Log in to the switch using an account with admin permissions.
3. Set the utility to capture output from the screen.
Some utilities require this step to be performed prior to opening up a session. Check with your
utility vendor for instructions.
4. Enter the command or start the process to capture the required data on the console.
Capturing command output
1. Connect to the switch through a Telnet or SSH utility.
2. Log in using an account with admin permissions.
3. Set the Telnet or SSH utility to capture output from the screen.
Some Telnet or SSH utilities require this step to be performed prior to opening up a session.
Check with your Telnet or SSH utility vendor for instructions.
4. Enter the command or start the process to capture the required data on the console.
Building a case for your switch support provider
The questions listed in “Basic information” should be printed out and answered in their entirety
and be ready to send to your switch support provider when you contact them. Having this
information immediately available expedites the information-gathering process that is necessary to
begin determining the problem and finding a solution.
Basic information
1. What is the switch’s current Fabric OS level?
To determine the switch’s Fabric OS level, enter the firmwareShow command and write down
the information.
2. What is the switch model?
To determine the switch model, enter the switchShow command and write down the value in
the switchType field. Cross-reference this value with the chart located in
Appendix A, “Switch
Type and Blade ID” .
3. Is the switch operational? Yes or no.
4. Impact assessment and urgency:
• Is the switch down? Yes or no.
• Is it a standalone switch? Yes or no.