beautypg.com

Chassis slots, Unpacking and installing the brocade vdx 8770-4 – Brocade VDX 8770-4 Hardware Reference Manual User Manual

Page 40

background image

20

Brocade VDX 8770-4 Hardware Reference Manual

53-1002563-04

Unpacking and installing the Brocade VDX 8770-4

2

Chassis slots

Switch slots are coded and numbered to differentiate between management module slots, switch
fabric module slots, and line card slots. Management modules (MMs) must be installed only in
slots M1 and M2. Switch fabric modules (SFMs) must be installed only in slots S1 through S3.
There must be at least one SFM installed in either slot S1 or slot S2. The line card slots, L1 through
L4, can be filled with any supported line cards. Unused slots must be filled with the correct filler
panels to maintain adequate cooling.

Unpacking and installing the Brocade VDX 8770-4

Use the following procedure to unpack and install your Brocade VDX 8770-4.

NOTE

A fully populated Brocade VDX 8770-4 weighs approximately 86.18 kg (190 lb) and requires a
hydraulic or assisted lift to install it. Use safe lifting practices when moving this product.

1. Unpack the Brocade VDX 8770-4.

a. Cut the bands that encircle the packaging.

b. Slide the upper portion of the cardboard shipping box up off the pallet and shipping tray.

NOTE

The Brocade VDX 8770-4 packaging incorporates a wood pallet and brackets. The switch sits
on top of a corrugated cardboard shipping tray.

c. Save the packing materials for use when returning a switch.

d. Leave the switch on top of the shipping tray and pallet if the switch must be transported to

the installation location.

2. Use a pallet jack or other assisted lift to transport the new switch to the installation area.

3. Using the rack mount instructions, install the rack components in the rack and mounting

flanges on the switch. The rack mount kit and instructions are shipped separately from the
switch.

4. Remove the accessory kit (cardboard box), packing foam, and anti-static plastic from the

switch and set them aside.

5. Remove the foam inserts around the base of the switch.

6. Use a lift to raise the switch to the correct level. If installing the switch in a rack, follow the

instructions provided by the rack kit manufacturer.

7. If applicable, lock the wheels of the lift.

8. Ensure that the switch is oriented so that the left side and port side (front) have access to

intake air.

9. Gently slide the switch onto the final installation surface, ensuring that it remains supported

during the transfer.

10. Before you apply power to the switch, you can install the MM, SFM, and line card modules as

well as power supplies to speed up your installation.