PreSonus StudioLive 24.4.2 - Manual (Page 41)

37
4 Controls
4.1 The Fat Channel
StudioLive™ 24.4.2/16.4.2
Owner’s Manual
4.1.4 Fat Channel Panning, Stereo Link, and Link Master
The Pan Control for each Input or Output bus is set
on the Fat Channel. The LED display shows the Pan
setting, and the encoder to the right of the display
controls panning for the selected input or output
bus. When two channels are linked as stereo pair, the
LED display will automatically change to stereo pan.
Stereo linking is done within the Fat Channel. Input channels, aux buses, and subgroups
can be linked to create a stereo pair. The stereo pairs are predefined and cannot be changed.
They are as follows:
Channels 1 and 2 Aux 1 and Aux 2
Channels 3 and 4 Aux 3 and Aux 4
Channels 5 and 6 Aux 5 and Aux 6
Channels 7 and 8 Aux 7 and Aux 8 (StudioLive 24.4.2 only)
Channels 9 and 10 Aux 9 and Aux 10 (StudioLive 24.4.2 only)
Channels 11 and 12 Subgroups 1 and 2
Channels 13 and 14 Subgroups 3 and 4
Channels 15 and 16
Channels 17 and 18 (StudioLive 24.4.2 only)
Channels 19 and 20 (StudioLive 24.4.2 only)
Channels 21 and 22 (StudioLive 24.4.2 only)
Channels 23 and 24 (StudioLive 24.4.2 only)
A stereo link can be enabled when either channel in the pair is selected.
When the Stereo Link button is illuminated, all dynamics settings, subgroup
assignments, and main assignments are pasted to the other channel in the pair.
Whichever channel is selected when the Link button is engaged will be
the Link Master. When either channel in the stereo link is selected, both
channels‘ Select buttons will illuminate, but the Link Master‘s ID number will
be displayed in the Selected Channel LED readout in the Fat Channel.
Power User Tip: Note that this is a nondestructive paste; when the Link button is
disengaged, the other channel‘s previous settings will be restored. For instance, if Channel
8 is selected when the Stereo Link button is engaged, all of Channel 8’s settings will be
copied onto Channel 7. If Channel 7 is selected when the Stereo Link button is engaged,
Channel 7’s settings will be copied onto Channel 8. Because the settings are copied
nondestructively, it is possible to A/B dynamics settings with the touch of two buttons.