PreSonus StudioLive 24.4.2 - Manual (Page 39)

35
4 Controls
4.1 The Fat Channel
StudioLive™ 24.4.2/16.4.2
Owner’s Manual
High-Mid EQ On/Off Button.
Turns the High-Mid EQ On/Off for
the Selected Input or Output Bus.
This button activates the High-
Mid band for the selected
input or output. The button
will illuminate to indicate
that the control is active.
The High-Mid EQ is available
for all input and output buses.
High-Mid EQ Frequency
Control. Sets and Displays the
Center Frequency of the High-
Mid EQ.
This encoder sets, and the meter
displays, the center frequency
of the High Mid band. You can
adjust the Center Frequency from
380 Hz to 5 kHz.
High-Mid EQ Q Control
(StudioLive 24.4.2 only). Sets
and Displays the Q of the High
Mid Frequency Band.
This encoder sets, and the
meter displays, the Q for the
High-Mid band. The Q is the
ratio of the center frequency
to the bandwidth. When the
center frequency is constant,
the bandwidth is inversely
proportional to the Q, so as you
raise the Q, you narrow
the bandwidth.
High-Mid EQ Hi Q Button
(StudioLive 16.4.2 only). Enables
a Narrow Bandwidth for the
High-Mid Band EQ on the
Selected Input or Output Bus.
Q is the ratio of the EQ band’s
center frequency to its
bandwidth. With a constant
center frequency, higher Q values
indicate a narrower bandwidth.
By default, the High Mid EQ is
set to a low Q of 0.55. When
the Hi Q button is engaged, the
bandwidth will narrow to 2.0 to
provide more exact control.
High-Mid EQ Gain Control. Sets
and Displays the Gain
Attenuation or Boost at the
Center Frequency.
This encoder sets, and the meter
displays, the gain cut or boost at
the center frequency of the High-
Mid band. The level of the center
frequency can be set between
-15 and +15 dB.
High EQ On/Off Button. Turns
the High EQ On/Off for the
Selected Input or Output Bus.
This button activates the High
band for the selected channel or
bus. The button will illuminate
to indicate control is active.
The High EQ band is available
for all input and output buses.
High EQ Frequency Control.
Sets and Displays the Center
Frequency of the High EQ.
This encoder sets, and the meter
displays, the center frequency
of the High band. You can adjust
the center frequency from 1.4 to
18 kHz.
High EQ Q Control (StudioLive
24.4.2 only). Sets and Displays
the Q of the High Frequency
Band.
This encoder sets, and the meter
displays, the Q for the High band.
The Q is the ratio of the center
frequency to the bandwidth.
When the center frequency
is constant, the bandwidth is
inversely proportional to the Q,
so as you raise the Q, you narrow
the bandwidth.