Yokogawa Standalone MW100 - Manual (Page 95)

-
95/131 -
IM MW100-S16E-1
Ed01
2.5.8. DNP client destination setting (WQ)
This command is used to configure destination of DNP client. For implementing DNP
communication functions, this command is added.
WQ p1, p2 (in case p2 is 65520) 22 23
WQ p1, p2, p3, p4, p5, p6, p7 (in case p2 is not 65520)
p1 : Destination number (01 to 10)
p2 : DNP address of DNP server (0 to 65520)
p3 : Publishing command for integrity poll (0 to 15)
0 : None (do nothing)
1 : Read Class 0
15 : Read Class 0, 1, 2, 3
p4 : Publishing command for event poll (0 to 15)
0 : None (do nothing)
14 : Read Class 1, 2, 3
15 : Read Class 0, 1, 2, 3
p5 : Switch to request unsolicited message (OFF, ON)
OFF : Not request
ON : Request
p6 : IP address of DNP server (0.0.0.0 to 255.255.255.255)
p7 : Service port of DNP server (1 to 65535)
- Query
WQ [p1] ?
22 Unless MATH and DNP option is specified, command can't be used.
23 When 65520 is set to p2, entry is disabled.