Yokogawa Standalone MW100 - Manual (Page 38)

-
38/131 -
IM MW100-S16E-1
Ed01
2.3.2. Enabling DNP slave/server functions
To use DNP slave/server functions of MW100, user should enable these functions at
first. Required steps to enable DNP Slave/server functions are shown in Figure 19 and
Figure 20. About the detail of the configuration, refer the explanation of Table 17 and
Table 18.
Figure 19. Required steps to enable DNP slave function
[step 1] select the function (driver)
[step 2] configure the slave DNP address
Screen of serial communication setting