Yokogawa Value Series FX1000 User Manual
Page 13
2-4
IM 04L21B01-63EN
Contents of the Basic Information Tab
Item
Description
File Name
The file name. (If the file name is long, the portion that does not fit within the dialog box is not
displayed.)
Device Type
FX1000
Serial No.
The device’s serial number.
File Message
The file message (up to 50 characters; specified as the file header).
Time Correction
Whether or not the time was changed while data was being acquired (done/none).
Start
Start Time
The time when data acquisition started (yyyy/mm/dd hh:mm:ss.mmm).
Started by
The name of the user who started data acquisition (up to 20 characters).
Starting Cond.
The condition under which data acquisition started (Manual/Restart after Black Out/Auto/Triggered
Restart/Over Write/Unknown).
Stop
Stop Time
The time when data acquisition stopped (yyyy/mm/dd hh:mm:ss.mmm).
Stopped by
The name of the user who stopped data acquisition (up to 20 characters).
Dividing Cond.
The condition under which data acquisition stopped (Manual/Black Out/Auto/Data Count/
Interrupted/Unknown).
Meas Ch.
The number of measurement channels.
Math Ch.
The number of math channels.
Ext. Ch.
This is not applied to the FX data.
Data Count
The number of data points.
Sampling Int.
The sampling interval, in seconds.
Trigger Time
The trigger time (yyyy/mm/dd hh:mm:ss.mmm).
Trigger No.
The trigger position (from 0).
Damage Check
The status of the data file (damaged/not damaged).
Comment
You can insert a print comment of up to 127 characters in length.
Contents of the Batch Information Tab
Item
Description
Batch Name
The batch name
(up to 32 characters).
Lot No.
The lot number
(range: 0 to 99999999).
Title 1 to Title 24
1
The batch text title
(up to 20 characters).
Description
The batch text description
(up to 30 characters).
1 You can use up to eight of these on the FX.
Contents of the Batch Comment Tab
Item
Description
Comment 1 to Comment 3 The time when the comment was made (yyyy/mm/dd hh:mm:ss.mmm).
The comment itself
The user who made the comment (up to 20 characters).
2.1 Starting and Exiting the Data Viewer