Asante Technologies Intrachassis 9000 - Manual (Page 72)

Basic Configuration
Page 3-30
Current Settings
Table 3-7 explains each setting on the Forwarding Database Configuration
Menu.
Table 3-7 Forwarding Database Configuration menu settings
Displaying the Forwarding Database
You can display the Forwarding Database MAC address table with or without
IP addresses. Use the following procedure to view the table.
1
Open the Unicast Forwarding Database Configuration
Menu by typing d in the Configuration Menu.
2
Type either a, p, or v , depending on the range of MAC addresses
you want to view.
Type a to display the MAC address table with the MAC
addresses of all ports on the IntraChassis 9000.
Type p to specify a port, then see the MAC addresses for
that port only.
Type v to specify a VLAN, then see the MAC addresses for
the member ports of that VLAN only.
3
At the prompt which appears, type y to see IP addresses in
the display or type n to see the display without IP addresses,
then press Return. The selected display appears, as shown
in Figure 3-15.
Setting Description
Age-out Time The number of seconds that addresses are retained in the table.
The default is 300 seconds. The range is from 10 to 1,000,000.
MAC Address Count The number of entries currently in the MAC Address Table.
IP Address Count The number of entries in the MAC Address Table that contain a
corresponding IP address.
GLXY9.book Page 30 Thursday, February 17, 2000 3:04 PM