Proface FP3900 - 19 Flat Panel" - Manual (Page 59)

5.1 Touch Interface Data
5-4 FP-2500/FP-2600 Series User Manual
5.2
Touch Panel Communication Programs For MS-DOS ®
When using MS-DOS ® on the FP-2500 Series units, MS-DOS ® Touch Panel Commu-
nication Programs for MS-DOS ® are required. These programs are contained in the
CD-ROM.
CD-ROM Data
• These programs run only on PC/AT compatible machines using MS-
DOS. Therefore, do not use a USB cable.
• These programs are only for FP-2500 Series units. FP-2600 Series
units cannot be used.
• When using a host device that does not have a CD-ROM Drive unit, copy
these programs to a floppy disk.
5.2.1 FPATPH.EXE (Touch Panel Handler)
FPATPH [parameter] or FPATPH -r
* Parameter Explanation
-a Selects the I/O address of the SIO port where the touch panel
is connected.
(hexadecimal, default = 2f 8)
n = 3f 8 (COM1)
2f 8 (COM2)
-q Selects the interrupt level (IRQ) for the SIO port where the touch
panel is connected. (default = 3)
n = 4 (COM1)
3 (COM2)
-i Sets the vector number for the function call's software interrupt.
(hexadecimal, default = 59)
-r Removes the current (resident) memory command.
-c Specifies the data file made by FPCALIB.EXE (touch panel data
FPcalibration) that contains the correction value.
"FPATPH. CAL" in the current directory is selected for default.
How to Operate the Software