Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 15)

Installation Procedure
PLC Ladder Monitor Operation Manual 1-6
1.3 Installation Procedure
• GP-Pro EX Manual and the Hardware Manual are available for download on
the Pro-face support site “Otasuke Pro!” (http://www.pro-face.com/otasuke/).
See the manual for GP-Pro EX Ver.2.00 or later.
Create a project file
Install the startup file
onto a CF Card
1
Install the add-on kit
2 )
“2.2.2 Setup Procedure” (page 2-4)
3
See: GP-Pro EX Reference Manual
4
Configure the
device monitor )
“2.2.2 Setup Procedure” (page 2-4)
5
Transfer the project
file with the device
monitor settings to
the display
See: GP-Pro EX Reference Manual
7
Install the CF Card
8
Connect the display
and PLC See: “CS/CJ Series HOST Link Drivers” or “CS/CJ Series Ether-
net Drivers” in “GP-Pro EX Device Connection Manual”
)
“2.2.2 Setup Procedure” (page 2-4)
9 Start up the Ladder
Monitor feature )
“2.2.2 Setup Procedure” (page 2-4)
6 Convert comment
file See: “Start up procedure from the 2.2.2 Setup Procedure Step 6”
(page 2-8)
See: GP3000 Series Hardware Manual