Extron Electronics VSC 500_700_700D User Guide - Manual (Page 44)

Rack mounting procedure
1. If feet were installed on the bottom of the VSC, remove them.
2. Place the scan converter on one half of the 1U (one unit high, one unit wide) rack shelf
(part number 60-190-01). Align the front of the VSC with the front of the shelf, and
align the threaded holes on the bottom of the VSC 500/700 with the holes in the rack
shelf.
3. Attach the VSC to the rack shelf with the two provided 4-40 x 1/8 inch machine
screws. Insert the screws from the underside of the shelf, and securely fasten them into
diagonally opposite corners, as shown in the following illustration.
Rack Mount VSC 500.eps
(2) 4-40 x 3/16" Screws
Use 2 Mounting Holes on
Opposite Corners
False Front Panel
Uses 2 Front Holes
VSC 50
0 SCA N C ONV ERT ER
SIZE
MIN /MA X
NEX T
MEN U
FRE EZE RES ET IR
CEN TER /PAN /SIZ E
Figure 33. Rack Shelf Mounting
4. Attach the false front panel (provided with the rack shelf) to the unoccupied side of
the rack (as shown above), or install a second half-rack width device in that side by
repeating steps 1 – 3.
5. Attach the rack shelf to the rack using four 10-32 x ¾ inch bolts (provided). Insert the
bolts through #10 beveled washers, then through the holes in the rack ears and rack, as
shown above.
VSC 500/700/700D User Guide • Reference Information 38