Extron Electronics VSC 500_700_700D User Guide User Manual
Page 10
b.
RGB (computer) input BNC connectors — Connect a computer video source
(RGBHV, RGBS, RGsB) via these five female BNC connectors. Connect cables for the
appropriate signal type, as shown here.
RGBHV
RGBS
R
G
B
V
H/HV
R
G
B
V
H
/HV
RGsB
R
G
B
H/HV
V
c
a.
Buffered loop-through VGA connector — For local monitor output of the input,
connect a monitor to this female VGA 15-pin HD connector.
b.
Buffered loop-through BNC connectors — For local monitor output of the
input, connect a monitor to these five female BNC connectors. Connect cables for
the appropriate signal type as shown in É above.
d
Output BNC connectors — Connect coaxial cables from a display device to these five
female BNC connectors for RGBHV, RGBS, RGsB, or component video output, as follows:
RGBHV
B/B-Y
G/Y
R/R-Y
H
V
OUTPUTS
RGBS
B/B-Y
G/Y
R/R-Y
H
OUTPUTS
B/B-Y
G/Y
R/R-Y
V
H
RGsB
V
B/B-Y
G/Y
R/R-Y
V
H
R-Y, Y, B-Y
e
Composite video output connector — Using a coaxial cable, connect a composite
video display device to this female BNC connector.
f
S-video output connector — Connect an S-video output device to this female 4-pin
mini DIN connector.
g
RS-232/RS-422 port — This connector provides for two-way RS-232/RS-422
communication. See “
”, for information on how to install and
use the control software and SIS commands.
The default protocol is 9600 baud, 1 stop bit, no parity, and no flow control.
The rear panel RS-232/RS-422, 9-pin connector has the following
DB9 Pin Locations
Female
5
1
9
6
pin assignments:
Pin RS-232 function Description
1
No connection
2
Tx
Transmit data
3
Rx
Receive data
4
Tx 2
Transmit data
5
Gnd
Signal ground
6
No connection
7
No connection
8
Rx 2
Receive data
9
No connection
VSC 500/700/700D User Guide • Installation and Operation
4