Extron Electronics VSC 500_700_700D User Guide - Manual (Page 23)

Shift Function
The following flowchart describes the shift feature. Shift an image to center it or move
it horizontally and vertically. From the default cycle, rotating either adjustment knob will
display the Shift menu. The Shift menu will also display when the Next button is pressed
from the Size menu.
Hsz 0512
Vsz 0512
Hsh 2048
Vsh 1024 NEXT NEXT
Shift control
• Shift or center the image
horizontally (default is 2048)
or vertically (default is 1024).
Extron
VSC 500
2 sec.
2 sec.
31.46KHz
59.94 Hz
NOTE: The Shift menu can also be displayed by turning either
adjustment knob while in the default cycle.
Figure 21. Shift Adjustment
Rotate the horizontal ([) or vertical adjustment knob ({) to shift the image horizontally or
vertically, respectively.
The Min/Max LED will light red whenever the adjustment range has reached its limit. Pressing
the Next button returns you to the Size menu.
NOTE: The default value for horizontal and vertical size is 0512. The default values
for the horizontal and vertical shift are 2048 and 1024, respectively. The actual
minimum and maximum values will vary and are based on the incoming scan
rate.
Freeze Mode
The displayed image may be prevented from being changed by pressing the Freeze and
Reset button at any time to enable this function. The Freeze and Reset LED will light green
when this button is pressed. Pressing the Freeze and Reset button again disables this
function (see note below) (see
Front Panel Features in this section).
NOTE: If freeze mode is enabled, pressing the Next button from the Auto Set main
menu will disable freeze mode.
Image
Frozen
Extron
VSC 500
2 sec.
2 sec.
31.46KHz
59.94 Hz
FREEZE/
RESET
NOTE: The Freeze and Reset button may be pressed
at any time and from any menu to freeze the
image. Press again to unfreeze the image.
Figure 22. Freeze Function
VSC 500/700/700D User Guide • Installation and Operation 17