Warner Electric SFC-1525 - Manual (Page 12)

12 Warner Electric • 800-825-9050 P-207 • 819-0516
SFC-1225 Clutch Coupling Flange Mounted Drawing I-25604
Armature View
Arm Shaft .750 – 2.687
Rotor Shaft .500 – 2.500
Static Torque 465 lb. ft.
Maximum Speed 3,000 rpm
Standard Voltage D.C. 6, 24, 90
All dimensions are nominal unless otherwise noted.
See page 28 for de tails
on Bush ings.
* Mounting holes are within .010 of true position relative to pilot
diameter.
** Mounting holes are within .008 of true position relative to pilot
diameter.
Field View
(Inside & Outside Mounted)
.234
.562
.281
.758
.742
1.562
.062
.562
1.750
.312
5/16-18
UNC-3A
7.531
.921
1.546
12.703
Max.
Dia. 12.625
Dia.
7.062
Dia.
4.093
Dia.
2.500
2.687
5.438
5.436
Pilot
Dia.
5.890 Max.
Removable plug in ends
for 1/2" conduit.
.350/.341 dia. (8)
holes equally
spaced on 6.062
dia.**
.358/.338 dia. (8) holes equally
spaced on 13.000 dia.*
6.378/6.376
Pilot Dia.
13.875/13.871
Pilot Dia.
3.750
8.687 Max.
.358/.338 dia. (6) holes equally
spaced on 7.250 dia.*
Customer Shall Maintain:
1. Concentricity of field mounting pilot diameter with
rotor mounting shaft within .006 T.I.R.
2. Squareness of field mounting face with rotor
mounting shaft within .006 T.I.R. measured at field
mounting bolt circle.
3. mounting shaft concentric with armature mounting
shaft within .006 T.I.R.
4. Angular alignment of shafts within 1/2 degree.
When Hub is Furnished by Customer:
Rotor mounting pilot diameter must be concentric with
rotor mounting shaft within .006 T.I.R.