Vanguard TRM-20_40 User Manual

Page 45

REV 1 TRM-20 AND TRM-40 USER’S MANUAL

p. After saving the readings, the following screen will be displayed:

Set the LTC or Voltage Regulator tap position to the position indicated on the LCD screen
and press the

[START]

key.

The TRM will continue the test and display the results as in step n. Repeat steps l
through o for all “Lower” positions and then through all “Raise” positions.

q. The following screen will be displayed after the last “Raise” position’s resistance reading

is stored:

1. YES

Press the

[1]

key (YES) to print the test results on the built-in thermal printer. A

Typical LTC/Voltage Regulator test report is shown in Figure 6. Continue to step
r.

2. NO

Press the

[2]

key (NO) to bypass printing of the test results. Continue to step r.

r. The following screen will be displayed:

1. YES

Press the

[1]

key (YES) to save the test record. The following screen will be

displayed:

SAVE THIS RECORD?
1. YES
2. NO

PRINT RECORD?
1. YES
2. NO

set tap to 2 lower

("START" to CONTINUE)

** XFMR ENERGIZED! **