Teledyne LeCroy Detective - Users Manual - Manual (Page 11)

CATC CATC Detective User’s Manual Version 2.21
Page 8
Note: The B-type USB connector on the Detective Probe is normally connected to the upstream
USB port, while the A-type connector is connected to the downstream port.
Note: Early versions of the USB Detective Probe do not contain the B-type USB receptacle.
These Probes have only the two A-type USB connectors..
The CATC Detective Bus & Protocol Analyzer hardware is now ready for operation.
3. SOFTWARE INSTALLATION (ALL VERSIONS)
3.1 General
The CATC Detective software is available in four different versions:
•
standard version for Windows 3.1 and Windows 95
•
standard version for Windows NT
•
view-only version for Windows 3.1, Windows 95, and Windows NT (This version does not
require the USB Detective hardware; it is used only for viewing and analyzing previously
created USB traffic files. Information on installing and using this version can be found in the
CATC Inspector Advanced USB Bus & Protocol Analyzer User’s Manual.)
•
demo version for Windows 3.1, Windows 95, and Windows NT (This version also does not
require the Detective USB hardware; it is made available for product demonstration purposes,
and can be used only for viewing and analyzing a specific set of USB traffic files.
Information on installing and using this version can be found in the CATC Inspector
Advanced USB Bus & Protocol Analyzer User’s Manual.)
The software diskette label identifies the program version. To install the CATC Detective
software, run the installation program from the Detective software diskette, and follow the
instructions on the screen. Note that to install the standard version on Windows NT systems, it is
necessary to log in as administrator.
•
For Windows 3.1 and 95 run the ‘install.exe’ installation program.
•
For Windows NT run the ‘setup.exe’ installation program.
The installation program creates a program group for the Detective application once it has
finished copying all the files. The icon for an Uninstall program is also placed in the program
group. This Uninstall program can be run later, if desired, to remove the CATC Detective
software from the system.
To run the software, double-click on the Detective icon in the program group created during
installation. Section 4 describes the software in detail.