Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual - Manual (Page 26)

Teledyne LeCroy Setting Up the Summit Z3‐16 Exerciser using an Ethernet Connection
26 Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual
Figure 3.5: Analyzer Devices Dialog Showing All Devices
The Summit devices in the list are marked:
 Locked: Some other client on the network is already connected to that device
 Ready to connect: Available for connection
The PETracer software fills the list with devices that are connected over USB or
discovered on the Ethernet network. The discovery mechanism works only within one
network subnet. If a Summit Z3‐16 Exerciser is connected to the network on a different
subnet, you can manually add it to the list if you know the IP address by clicking the Add
Device button.
Figure 3.6: Add Ethernet Attached Device
6. If a Summit device is marked Ready To Connect, you can select that device and press
the Connect button to execute the connection procedure.
After the connection is established, the application displays the Connection Properties
dialog (see
Figure 3.7 on page 27 ).