Teledyne LeCroy Summit Z3-16 PCI Express Multi-lane Exerciser User Manual - Manual (Page 21)

Summit Z3‐16 PCI Express Multi‐Lane Exerciser User Manual 21
PCI Express Test Platform 16x2.5GT/s / 16x5.0GT/s / 16x8.0GT/s Teledyne LeCroy
Reference Clock In Connector
This connects the external reference clock source that can be selected by an external
clock selection switch. The clock will be delivered to both PCIe slots.
Reference Clock Out Connector
This provides external reference clock output.
Summit Z3-16 Slot Connector
This is designed to be used with the Summit Z3‐16 Exerciser. It can also be used with
other equipment and is powered via the PCI Express Test Platform.
DUT Slot Connector
This connector is designed to be used with the DUT. Power to this slot is controlled by the
DUT Power switch. When the DUT power switch is off all the DUT power is off including
auxiliary power.
DUT Power Connector
DUT 6‐Pin DC Power Connector which supplies 12 Volts up to 6.25 Amps for cards needing
more power, such as a graphic card. Cables are provided for this connector.
DUT 8‐Pin DC Power Connector which supplies 12 Volts up to 12.5 Amps for cards needing
more power, such as a graphic card. Cables are provided for this connector.
Output Connectors
Two output iPass Connectors are provided for use with a Protocol Analyzer.
To Analyzer (15:8) Connector
Connects to Summit T3‐16 Analyzer (lanes 15:8). This is an optional connection for users
adding a Summit T3‐16 Analyzer to their setup.
2.5.2 To Analyzer (7:0) Connector
Connects to Summit T3‐16 Analyzer (lanes 7:0). This is an optional connection for users
adding a Summit T3‐16 Analyzer to their setup.
2.5.3 LEDs
When powered on, the PCI Express Test Platform powers the Summit Z3‐16 Exerciser and
activates user accessible controls and LEDs on the back of the card.
DUT PRSN LED
There are four DUT PRSN LEDs that show the state of the DUT x1, x4, x8 and x16 present
signals.
Power Monitor LED
There are two LEDs to monitor power to the lower PCIe slot indicating 3.3V or 12V.