Teledyne LeCroy Summit Z2-16 PCI Express Multi-lane Exerciser User Manual - Manual (Page 27)

Summit Z2-16 Exerciser User Manual Chapter 3: Installation
Teledyne LeCroy
23
3.5 Connecting Summit Z2-16 to a T2-16
The Summit Z2-16 Exerciser connected to a Summit T2-16 Analyzer.
• For an x8 connection: Connect one end of the iPass Y-Cable to the To
Analyzer [7:0] connector of the Summit Z2-16. Connect the other two ends of
the iPass Y-Cable to the Upstream [7:0] and Downstream [7:0] connectors of
the Summit T2-16 respectively.
• For an x16 connection: In addition to the above connection, connect one
end of the second iPass Y-Cable to the To Analyzer [15:8] connector of the
Summit Z2-16. Connect the other two ends of the iPass Y-Cable to the
Upstream [15:8] and Downstream [15:8] connectors of the Summit T2-16
respectively.
Figure 3.5 Summit Z2-16 Exerciser (top) connected to a Summit T2-16 (bottom).