Teledyne LeCroy Summit Z2-16 PCI Express Multi-lane Exerciser User Manual User Manual
Page 24
Chapter 3: Installation
Summit Z2-16 Exerciser User Manual
20
Teledyne LeCroy
Installing the Device Emulator
To install the Device Emulator into the DUT, perform the following steps:
Step 1 If not already powered off, power off the Summit Z2-16 system and the
DUT.
Step 2 Insert the edge connector on the Device Emulator into a PCI Express
slot in the DUT. The Device Emulator is designed to fit into standard x16
PCI Express slot. To connect to a x1, x4, or x8 slot, you must install a slot
reducer, available from Teledyne LeCroy.
Step 3 The Device Emulator is shipped from Teledyne LeCroy with a metal face
plate for attachment to a PC case. If you are working with a motherboard
that is not in a PC case, you may prefer to remove the metal face plate
so the emulator can sit flat with the motherboard. To remove the face
plate, unscrew the two screws that hold it onto the emulator.
Step 4 Attach probe data cables between the two connectors on the emulator
and the To Device (15:8) and To Device (7:0) ports on the Exerciser.
Step 5 At this point the emulator is ready for use. Skip ahead to See “Final