Step 4. hang display onto the wall plate, Figure 8, Figure 9 – Staub Electronics SM-RAZOR-T-XL STRONG - LARGE RAZOR TILT MOUNT FOR 55-80 IN. FLAT-PANEL TVS User Manual
Page 8
SM-RAZOR-T Installation Manual
pg.8
www.snapav.com Support: 866.838.5052
Step 4. Hang Display onto the Wall Plate
A. Carefully lift the display and place the bracket hooks over and onto the angled
lip in the wall plate (Figure 8). Do not release the display until it is completely
connected to the wall plate.
B. Pull the release strings down on both sides of the display, and gently press on
the bottom of the display to lock the brackets onto the wall plate. (Figure 9)
C. Let the release strings slide back up, and check to see that the catches engage
by gently pulling the bottom of the display.
After the mount is installed, the display can be connected to the wiring. Then, final level
and tilt adjustments can be made. See the the following sections for more details.
Figure 8
Installing
Locked
Figure 9