KB Electronics KBDA-42 - Manual (Page 7)

2 SAFETY WARNING
Definition of Safety Warning Symbols
Electrical Hazard Warning Symbol – Failure to observe this warning could result in electrical
shock or electrocution.
Operational Hazard Warning Symbol – Failure to observe this warning could result in serious
injury or death.
6
This product should be installed and serviced by a qualified technician, electrician, or
electrical maintenance person familiar with its operation and the hazards involved. Proper
installation, which includes electrical connections, fusing or other current protection, and grounding,
can reduce the chance of electrical shocks, and/or fires, in this product or products used with this
product, such as electric motors, switches, coils, solenoids, and/or relays. Do not use this drive in
an explosion-proof application. Eye protection must be worn and insulated adjustment tools must
be used when working with drive under power. This product is constructed of materials (plastics,
metals, carbon, silicon, etc.) which may be a potential hazard. Proper shielding, grounding, and fil-
tering of this product can reduce the emission of radio frequency interference (RFI) which may
adversely affect sensitive electronic equipment. It is the responsibility of the equipment manufactur-
er and individual installer to supply this Safety Warning to the ultimate end user of this product. (SW
1/2006)
The drive contains electronic Start/Stop circuits, which can be used to start and stop the drive.
However, these circuits are never to be used as safety disconnects since they are not fail-safe. Use
only the AC line for this purpose.
Be sure to read and follow all instructions carefully. Fire and/or electrocution can result due to
improper use of this product.
This product complies with all CE directives pertinent at the time of manufacture. Contact our
Sales Department for Declaration of Conformity. Installation of a CE approved RFI filter is
required. See Table 1, on page 9. For some applications, additional shielded cables, filters, and chokes
may be required along with a signal isolator (IODA Input/Output Multi-Function Board (Part No. 9668)).